PW3d Blog
A blog about 3d graphics, Animation:Master, PW3d, 3d printing, Windows 10(m) and much more.
You want to get notifications if there is new content here? Just subscribe now to the blog.
Last edit: 01. Jan. 2022, 16:15h
Happy New Year 2022
I of course wish every reader a happy and prosperous 2022 :). This small print along with a small second 3d print of a pants clip for a phone ushers in this year 3d print wise for me :). Hope you also find a good start and have fun in the new year 2022. Here’s to a wonderful 2022
Last edit: 23. Dec. 2021, 21:43h
Merry Christmas 2021
Christmas is just around the corner and as always I would like to wish you and your families a Merry Christmas. This year there was a 3d-printed goat greeting for friends, family and colleagues and so I do not want to withhold the goat here neighter. :) Have a great Christmas, have fun and recover well in this hard time - hopefully the last time christmas will be with such contact restrictions. And now: Merry Christmas!
Last edit: 27. Nov. 2021, 00:04h
X or Y offset when printing with the Replicator 2
Every now and then there is a little problem with the Makerbot Replicator 2. Every now and then means: After 6 years I have a little problem with the printer again, because it slips a little bit during printing and thus suddenly continues the print at a wrong place. There are a few different possibilities why this happens and here are 2 links or videos what you can do about it: Problem 1: Loose belts / retensioning the motors. At some point ...
Last edit: 19. Nov. 2021, 22:42h
WebCam shutter by 3d printer
Older webcams deserve a shutter too, so someone isn’t watching when they shouldn’t ;). My attempts to build an exactly round, perfectly fitting lid were unfortunately not immediately successful (FDM printers rarely manage to deliver exactly round results. Most of the time they become slightly oval or at least not completely round when there are thin edges. Thus, I then decided to take a different approach and built a push-on design from ...
Last edit: 11. Apr. 2021, 16:53h
Keyboard stands like to break...
The day before yesterday, my 1.5 liter water bottle fell on my upturned keyboard. It was locked, but the force of the impact alone caused the little stand for raising the keyboard to break, and so the usual keyboard wobble started. Normally this would be the moment you buy a new keyboard because a 2.5cm by 1.5cm by 2mm thick piece of plastic with no moving parts broke. I found that somehow... wasteful of resources. So I fired up my 3d printer ...
Last edit: 05. Apr. 2021, 23:28h